All steel! One piece! Shaving sharp - with no loose blades ever! HellRazor broadheads are the ultimate cut-on-contact one-piece broadheads designed to maximize accuracy and penetration out of today's fast, high-performance bows.

Practice makes perfect! Don't use your hunting heads to practice with, we carry a dedicated practice head to get your setup tuned to perfection.

AVAILABLE WEIGHTS	CUTTING DIAMETER
100 grain, 125 grain	1-1/8"

1. Q: What's the best way to resharpen my HellRazor broadheads?
   
   A: Any good flat fine grit sharpening stone can be used to resharpen the HellRazor. The finer the grit, the better the edge potential. Any place that sells woodworking supplies carries them. The stone should be at least 1-1/2” wide by 4” long.
   
   INSTRUCTIONS: Mount the broadhead to an arrow for safety. Put a little light oil on the stone (3-in-1 works well) and gently lay the broadhead on the stone at one end with the point pointed away from you. With light to moderate pressure pushing down, pull the broadhead back towards you. Use extreme caution. Lift the head up, index it to the next side and repeat. Repeat again for the third side. Index the head again and repeat for the first side but cut the pressure in half. Wipe off the blade with a soft clean cotton cloth. Take a short length of aluminum arrow about 10 inches long. Hold the broadhead tipped arrow in one hand and the short arrow in the other. Lay the aluminum arrow across one of the sharpened sides at the back of the broadhead. Using light pressure pull the aluminum arrow towards the tip of the broadhead until it falls off. Repeat this procedure for each side and repeat the first side. This removes the wire edge from the blade and hones the edge to hair-shaving sharpness. You may have to repeat a couple of times. This technique can come real close to duplicating NAP’s factory sharpness if done right.